Home > Previous > Details
LCD dual band repeater cellphone booster signal amplifier
Name:
Tel:
E-mail:
Subject:
Enquirer:
Code:
  
点这里关闭本窗口

LCD dual band repeater cellphone booster signal amplifier

        Project

 Item No.

 Uplink

 Downlink

Frequency(MHz)
for choose

 GSM+DCS (JR-GD17)

 890-915/1710-1785

 935-960/1805-1880

 GSM+WCDMA (JR-GW17)

 890-915/1920/1980

 915-960/2110-2170

 CDMA+PCS (JR-CP17)

 824-849/1850/1910

 869-894/1930-1990

CDMA+WCDMA (JR-CW17)

 824-849/1920/1980

 869-894/2110-2170

 CDMA+DCS (JR-CD17)

 824-849/1710-1785

 869-894/1805-1880

gain(dB)

60

65

Band flatness(dB)

CDMA&GSM≤±3                             DCS&PCS&WCDMA≤±6                           

Output Power(dBm)

13±2

17±2

ALC(dB)

31

VSWR

≤2.5

Group delay(uS)

≤1

Impedance

50ohm

Working tempreture(℃)

 -25℃~+55℃

Connector type

N-Female

Working voltage

AC110V220V to DC+5V/1A

Size(mm)

155*130*22

Packing Size(mm)

250*240*65

Net Weight(Kg)

0.8KG

MTBF

50000hours

Installation Type

Wall Installation

Waterproof Rate

IP40

Installation for Cellphone signal repeater gsm 900/1800mhz signal booster:

Step 1 Start by taking your phone up to the roof or other location outside to find where the signal is strongest.

Step 2 Temporarily mount the Outdoor (outside) antenna in that location. You may need to adjust and move the antenna later.

Step 3 Run coaxial cable into the building to a convenient loaction (attic, etc.) where you can also get standard power for the Signal Repeater.

Step 4 Place the Signal Repeater in that location and connect the coaxial cable to the Outdoor Side of the Signal Repeater and the Outdoor antenna.

Step 5 Mount your Indoor (inside) antenna in a productive location. You may need to adjust or move the antenna later. More notes on Indoor antennas and patterns here.

Step 6 Connect coaxial cable between the Indoor antenna and the Signal Repeater output port.

Step 7 Power up the system and check for signal inside the building. If needed, tune system by moving and or pointing the Outdoor and Indoor antennas until they get the most signal possible.

Step 8 Secure all antennas and cables, securely mount the Signal repeater and clean up the installation.

Of course there are still a few more things to consider but in general, this is the basic procedure. For more information, please contact us.

Technique supporting for Cellphone signal repeater gsm 900/1800mhz signal booster:

1) If still no signal receipt after activated repeater, please check if outdoor antenna point to signal tower or elsewhere have strong signal and check if strength achieve -70DBM.

2) If can not call out, please adjust the direction of outdoor antenna.

3) If strength is not steady, please check if outdoor & indoor antennas are too close.  Please ensure the outdoor and indoor antennas have distance of 10 meters at least, with a wall between and not in a same horizontal line.

To use this product to enlarge your signal, the outdoor signal shall be as good as possible. The product will not work well if our outdoor signal is not good or bad.

Noted for Cellphone signal repeater gsm 900/1800mhz signal booster:

The distance between the outdoor antenna and the amplifier is not more than 30 meters

The outdoor Antenna not close to a large antenna, high-voltage lines, transformers, or metal mesh, etc.

The distance between the indoor antenna and the amplifier is not more than 40 meters

The indoor antennas do not close to the wall as far as possible in order to increase the coverage area

The indoor antenna and the outdoor antenna are advised to stay away from each other for more than one floor distance to prevent cyclic signal amplification

If lack of communication quality, please change the installation position of the outdoor antenna and adjustment the indicate direction of antenna

It is best to enclose waterproof tape at the junction, and prevent moisture narrow the indoor signal coverage area

Try to straight the cable, do not bend more than 90 degree